ETSI Mobile WiFi Especificaciones descargar pdf (Pagina 74)

ETSI

Final draft ETSI EN 300 328 V1.8.1 (2

012

04)

C.4.2.3 Test method

The test procedure shall be as follows:

• Replace the substitution antenna with the UUT once the calibration is performed.

• The UUT shall be positioned for maximum e.i.r.p. towards the horn antenna.

NOTE: This position was recorded as part of the procedure in clause 5.3.2.2.2 (second paragraph).

The test method is further as described under clause 5.3.7.2.1.

1 2 ... 69 70 71 72 73 74 75 76 77 78 79 ... 84 85

Contents 3
Intellectual Property Rights 8
Foreword 8
Introduction 8
1 Scope 9
2 References 9
2.2 Informative references 10
3.1 Definitions 11
3.2 Symbols 13
3.3 Abbreviations 13
4 Technical specifications 14
4.3 Technical requirements 15
4.3.1.3.2 Limit 16
4.3.1.3.3 Other Requirements 16
4.3.1.2.2 Limit 16
4.3.1.2.3 Conformance 16
4.3.1.3.1 Definition 16
4.3.1.7.1 Definition 20
4.3.1.7.2 Limits 20
4.3.1.7.3 Conformance 20
4.3.1.8.1 Definition 21
4.3.1.8.2 Limit 21
4.3.1.8.3 Conformance 21
4.3.1.9.1 Definition 21
4.3.1.11 Receiver Blocking 22
4.3.2.1 RF output power 23
4.3.2.4.1 Definition 25
4.3.2.4.2 Limit 25
4.3.2.4.3 Conformance 25
4.3.2.6.1 Definition 28
4.3.2.6.2 Limits 28
4.3.2.6.3 Conformance 28
4.3.2.7.1 Definition 29
4.3.2.7.2 Limit 29
4.3.2.7.3 Conformance 29
4.3.2.8.1 Definition 29
4.3.2.10 Receiver Blocking 30
5.1 Conditions for testing 31
5.1.2 Test mode 32
5.1.6 Test Fixture 34
5.3.1 Product Information 35
Utilisation 36
5.3.2.2 Test method 37
5.3.3.1 Test conditions 39
5.3.3.2 Test method 39
5.3.4.1 Test conditions 40
5.3.4.2 Test method 41
5.3.5.1 Test conditions 42
5.3.5.2 Test method 43
5.3.6 Void 45
5.3.8.1 Test conditions 52
5.3.8.2 Test method 52
5.3.9.1 Test conditions 53
5.3.9.2 Test method 53
5.3.10.1 Test conditions 55
5.3.10.2 Test method 55
5.3.11.1 Test conditions 58
5.3.11.2 Test method 58
Annex A (normative): 61
Table (HS-RTT) 61
Annex B (normative): 64
B.1 Radiation test sites 64
B.1.2 Semi Anechoic Room 65
B.1.4 Measurement Distance 67
B.2 Antennas 68
B.3 Test fixture 69
B.5 Coupling of signals 70
Annex C (normative): 71
C.3 Substitution measurement 72
Mechanism) 73
C.4.2.3 Test method 74
Annex D (informative): 75
D.1 Introduction 75
D.2 Possible Modulations 75
D.3.1 Guidance for Testing 76
Annex E (informative): 77
Application form for testing 77
EN 300 328 V1.8.1) 82
E.3.3 About the UUT 83
Annex F (informative): 84
History 85

Comentarios a estos manuales

Sin comentarios

ETSI Mobile WiFi Especificaciones Pagina 74

Comentarios a estos manuales